[. . . ] (×1) (×1) (×1) (×1) (×1) (×2) (×4) (×4) Warning / Avertissement / Advertencia The unit can only be installed in a car with a 12 V DC power supply, negative ground. If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. [. . . ] Make sure the faceplate will not hit the lid of the console (if any) when closing and opening. After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. If the fuse blows, first make sure the wires are not touching to cause a short circuit, then replace the old fuse with one that has the same rating. Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the · Wires or ground them to any metal part in the car. When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). Do not touch the metal part of this unit during and shortly after the use of the unit. If you experience problems during installation, consult your Kenwood dealer. Indd 1 11/15/10 12:09:26 PM Basic procedure / Procédure de base / Procedimiento básico 1 Remove the key from the ignition switch, then disconnect the · \ “Wiring connection” 3 Install the unit to your car. \ “Installing the unit” 4 Reconnect the · To the terminal that is grounded when either the telephone rings or during conversation. [. . . ] 2 Engage the catch pin on the removal tools into the holes on both sides of the escutcheon, then pull it out. 3 Insert the removal tools deeply into the slots on each side, then follow the arrows instructions as shown on the right. [. . . ]